Mazda RX-7 S1 First generation 1978 - 1985 Reserved Parking Fridge Magnet
Mazda RX-7 S1 First generation 1978 - 1985 Aluminum Parking Fridge Magnet
The first generation of the RX-7 was a two passenger car that was produced from 1978 through 1985 with a total of 471,018 examples built. The mass RX-7 is commonly referred to as the “SA22C” from the first alphanumerics of the vehicle identification numbers. The most famous aspect of this vehicle is probably the engine. It was a revolutionary engine created by Felix Wankel and named the “Wankel Rotary Engine”> Inside an elongated chamber, a rotor with three curved ides revolves around a central driveshaft. Air and fuel enter from the sides and are compressed as the rotor spins. The result is the equivalent of a conventional combustion chamber. The compact rotary engine installed behind the front axle, gave a great balance front / back weight balance, and provides a low center of gravity for a “small” and lightweight car. The engine displaces 70 cubic-inches and offered 100 horsepower at 6,000 RPM and 105 foot-pounds of torque at 4,000 RPM.
In 1981, integrated plastic-covered bumpers were added, along with wide black rubber body side moldings and wraparound taillights. By the mid 80s, disc brakes were located at the four corners.
Perfect for all car enthusiasts that want to show their passion for their Mazda RX-7 S1 First generation 1978 - 1985. Make room on the fridge and make it clear: Your Mazda RX-7 S1 First generation 1978 - 1985 deserves a reserved parking spot in the middle of the other magnets. The magnet is 2” x 3” (77 x 51 mm) and is quality made of .045” Aluminum that will not fade or break. It has rounded corner and a 1/2 inch square magnet in the back. Stick it to anything you'll like, on your fridge, workbench, toolbox, or man cave board. The colors are brights, vibrants and contrast beautifully. For any car guy, this is the ideal gift to add style and show their pride, even in the middle of the kitchen.
Available in: One color style only
- Made of 0.045” (1.14 mm) Durable Aluminum Material
- Size 3" x 2" (76.2 mm x 50.8 mm)
- Water-resistant & easy to clean
- 1” backer magnet for adhesion
This product is made in the USA
*MAZDA or any other marks are registered trademarks. Our products are not approved by any of these manufacturers and trademarks. We do not imply any association with these manufacturers and references are based on historical information in the public domain.
