Mazda RX-7 S1 First generation 1978 - 1985 Reserved Parking Only Sign
Mazda RX-7 S1 First generation 1978 - 1985 Aluminum Parking Sign
The first generation of the RX-7 was a two passenger car that was produced from 1978 through 1985 with a total of 471,018 examples built. The mass RX-7 is commonly referred to as the “SA22C” from the first alphanumerics of the vehicle identification numbers. The most famous aspect of this vehicle is probably the engine. It was a revolutionary engine created by Felix Wankel and named the “Wankel Rotary Engine”> Inside an elongated chamber, a rotor with three curved ides revolves around a central driveshaft. Air and fuel enter from the sides and are compressed as the rotor spins. The result is the equivalent of a conventional combustion chamber. The compact rotary engine installed behind the front axle, gave a great balance front / back weight balance, and provides a low center of gravity for a “small” and lightweight car. The engine displaces 70 cubic-inches and offered 100 horsepower at 6,000 RPM and 105 foot-pounds of torque at 4,000 RPM.
In 1981, integrated plastic-covered bumpers were added, along with wide black rubber body side moldings and wraparound taillights. By the mid 80s, disc brakes were located at the four corners.
Make it clear: Your Mazda RX-7 S1 First generation 1978 - 1985 deserve a reserved parking spot in your garage! Just like the real street signs, our signs are quality made of .025" Aluminum that will not rust, crack or break and are UV protected for outdoor use and durability. The sign has rounded corner and two 1/4 inch pre-drilled holes on top and bottom for easy display. Ideal for home, garage, office, workshop, Man cave, private roadways or anywhere you fill you deserve a special parking or deco spot, and they make the ideal gift for any car enthusiast. They are available in two sizes 12" X 18" (305 X 457 mm) or 8" X 12" (203 X 305 mm) to suit your need and space. Mazda RX-7 S1 First generation 1978 - 1985 Parking Only Sign.
Available in two sizes: 12" X 18" (305 X 457 mm) or 8" X 12" (203 X 305 mm)
.025" Aluminum
Rounded corners
Two 1/4 inch pre-drilled holes on top and bottom
UV protected for outdoor use and durability
This product is made in the USA
*MAZDA or any other marks are registered trademarks. Our products are not approved by any of these manufacturers and trademarks. We do not imply any association with these manufacturers and references are based on historical information in the public domain.
